Naxo nx 21 Tweak or how to improve the AT binding Naxo nX21 further.

Warning this small test is strictly nonscientistic!

I just forced the skis down to a stable table put a rigid tight fitting aluminum profile about 700mmn long in to the boot.

Then used a digital fish scale to make sure to use the same force in each off my measuring.

I used a long millimeter divided scale to measure distance to the wall in the back at the top of the aluminum profile.

I got this figures:

1. with no force on de scale 605mm to the back wall 605mm no movement :0)

2. With 6.5kg force on the fish scale standard binding 725mm a 120mm movement

3.With 6.5kg force on the fish scale modified binding 700mm a 95mm movement (20% less)

But as mentioned earlier this is strictly low quality science measurements.

This image show you how I shortened my rails of

to further improve the torsion rigidity of the NX 21 binding.

This operation demands power tools.

Good luck with your tweaking/ Stefan